Rice Lake Lift Truck/Pallet Jack Scales - CLS-Series User Manual
Page 14
Advertising
10
CLS Series Service Manual
the flexure rod in the direction of the flexures.
Figure 2-13. Centering the Flexure Rod
27. Use a pry bar or chisel to hold the load cell (bottom half of the cell), straight while using a torque wrench
to tighten the bottom hex nut on the lower mounting block to 110 ft/lb. Install the other hex nut on the
bottom of the flexure rod and torque it to 110 ft/lb.
Figure 2-14. Centering the Load Cell Using a Chisel
I n s e r t f l a t b l a d e
screwdriver here to help
center the flexure rod
Advertising
This manual is related to the following products: