0 junction box replacement, Junction box replacement – Rice Lake Lift Truck/Pallet Jack Scales - CLS-Series User Manual
Page 16
12
CLS Series Service Manual
3.0
Junction Box Replacement
The CLS Series scale uses a NEMA 4X polycarbonate junction box. The junction box is located between the
front and back panel of the scale and is covered by a metal cover plate on the top of the scale. Use the following
procedures for replacing a junction box on the CLS Series Cargo Lift Scale.
1. Remove the bolt that holds the top metal cover plate in place which conceals the junction box.
Figure 3-1. Top Cover Plate (scale shown not mounted on the forklift)
2. Remove the top cover plate and set aside.
3. Lift the fork lift to a comfortable working height.
4. Remove the two screws securing the junction box to the scale. See Figure 3-2 for screw location.
Figure 3-2. Screw Locations
R e m o v e b o l t t h a t
holds the top cover
plate on the scale to
a c c e s s t h e s m a r t
junction box.
S m a r t J u n c t i o n
Box Location
Screw locations