Rice Lake CLS-920i Cargo Lift Scale Installation Manual - Manual (Page 40)

Table 4-5. CLS-920i Serial Menu Parameters
SERIAL Menu
Parameter Choices Description
Level 2 submenus
PORT 1
PORT 2
PORT 3
PORT 4
…
PORT x CMD
PROGIN
KEYBD
SCALE
IND SC
IQUBE Specifies the type of data received by the port:
CMD: Remote command input
PROGIN: Programmable input
KEYBD:
Remote keyboard input
SCALE: Legal-for-trade serial scale input
IND SC: Industrial (non-legal-for-trade) scale input
IQUBE: iQUBE serial scale input
KEYBD is available only on Port 2; SCALE, IND SC, IQUBE, and HIPREC are available only on
Ports 3 and 4 and higher (expansion ports).
Note
The keyboard interface is not hot-pluggable. Power-off the 920i before
plugging the keyboard cable into the Port 2 connector.
Level 3 Submenus Port 1–Port 32
CONFIG 4/0/0/0
8/0/0/0
8/4/0/0
8/4/4/0
8/8/0/0
4/4/0/0
4/4/4/0
4/4/4/4
4/8/0/0 iQube board configuration.
CELLS CELLA1
CELLA2
CELLA3
CELLA4 iQube load cell configuration
SECTION PAIRED
CIRCULAR iQube section definition
PLATFRM A1
A2 iQube platform definition
SYSTEM PLATFRM1 iQube platform definition
ALGOUT SOURCE
FULLSC iQube analog output definition
DIGIO Leave at
default setting iQube digital I/O configuration
IQDIAG Leave at
default setting iQube diagnostics parameter
TESTCOM VALIDATE iQube communications tester
PORTTYPE 232
485 Specifies whether Port 4 is used for RS-232 or RS-485 communications. If 485 is selected,
additional prompts are shown to specify half- or full-duplex operation and RS-485 address.
Note
RS-485 communications can be specified for Port 4, and for odd numbered
expansion ports 5 and higher.
36 CLS-920i Installation Manual