Load cell tb3 – Rice Lake DWM-IV Digital Weighmeter Model 5 User Manual
Page 8
Advertising
3.2 Load Cell Connection
Connect the supplied seven position load cell terminal block to the load cell cable
according to the following table legend. Refer to the manufacturer of the load
cell(s) used for the wire color codes.
If the load cell does not provide the +/- Sense leads, jumper the +EXC to the +SEN
and EXC to the SEN terminals for proper operation. Insert the load cell terminal
block onto TB3 of the Model 5 circuit board. The unit is now ready for setup/calibration.
Apply power via the wall transformer.
Load Cell
TB3
+Excitation
+EXC
-Excitation
-EXC
+Signal
+SIG
-Signal
-SIG
+Sense
+SEN
-Sense
-SEN
Shield
SHLD
Advertising