5. error alerts – Rice Lake GoDEX DT4 User Manual User Manual
Page 17
DT2 / DT4 User Manual
15
3-5. Error alerts
LED
indicator
Beeps
Description
Solution
Red
2 x 4 beeps
The print mechanism is not
correctly closed.
Open the print mechanism and close
it again.
Red
(flashing)
None
High temperature at the print
head.
Once the print head has cooled
down, the printer switches to
standby mode.
Red
2 x 2 beeps
No paper is detected.
Make sure that the label sensor is
positioned correctly. If the sensor
still does not detect the paper, run
the auto-detection function
again.
The paper is finished.
Replace the label roll.
Red
2 x 2 beeps Paper feed problem.
Possible reasons: the print medium
has become trapped around the
rubber roll; the sensor cannot detect
a gap or black mark between the
labels; there is no paper. Please
reset the sensor.
Red
2 x 2 beeps
The memory is full. The printer
prints the message "Memory
full".
Delete unnecessary data or install
additional memory.
Red
2 x 2 beeps
Unable to find file. The printer
prints the message "Filename
cannot be found".
Use the "~X4" command to print all
files. Then check whether the files
exist and whether the names are
correct.
Red
2 x 2 beeps
A file of the same name already
exists. The printer prints the
message "Filename is repeated".
Change the name of the file and try
storing it again.