3. labels with black marks – Rice Lake GoDEX DT4 User Manual User Manual
Page 33
Advertising
DT2 / DT4 User Manual
31
6-3. Labels with black marks
If you are using black-mark label stock that has the printer's maximum feed width, the printer
may not recognise the black marks because they are outside the sensor range. When using label
stock with black marks, you should therefore observe the following restrictions:
DT2
For 60 mm wide label stock, the black marks should have the following positions and sizes:
A > 13.1 mm high
B < 5mm high
C > 8.1 mm high
DT4
For 118 mm wide label stock, the black marks should have the following positions and sizes:
A > 10.05 mm high
B < 1.95 mm high
C > 8.1 mm high
Advertising
This manual is related to the following products: