Rice Lake Star LC-7211 Form Printer User Manual
Page 75
67
❏
While holding down the control panel’s
LF
and
ON
LINE
buttons, turn the
printer back on to enter the Dot Adjustment Mode.
The printer will print something like the following.
Note that the printer will feed the paper forward and back each time during
this operation so you can view the printout.
❏
If the three lines do not align properly, use
FONT
to move the middle line
to the left or
MODE
to move it to the right.
The above step performs alignment for DRAFT mode only. You must make
separate adjustments for the D-DENSITY/SPEED, D-DENSITY P-
GRAPHICS, NLQ, QUADRUPLE-DENSITY, NORMAL-DENSITY,
PLOTTER-GRAPHICS, CRT GRAPHICS-I, CRT GRAPHICS-II, and
DOUBLE-DENSITY modes as well.
❏
Press
LF
to change to another printing mode.
❏
Repeat the above steps for each printing mode, if necessary.
❏
After making changes to the adjustments, press
ON LINE
to exit the Dot
Adjustment Mode and register your adjustments.
***
DOT ADJUSTMENT SETTING
***
DRAFT
0: