Rice Lake SURVIVOR SST3 Washdown Printer User Manual
Page 10
Introduction
7
14. Place the half clamp plate onto the studs, then place the clamp plate onto the studs with the step facing
down and the half plate nesting in the step of the clamp plate.
Figure 1-12. Place Half Clamp Down on Assembly
15. Press the assembly down and partially tighten the four nuts that hold the entire assembly in place. Once
all the nuts are started, tighten the nuts in a diagonal sequence until all the nuts are tight using a 7/16”
socket and torque wrench. Tighten to 30 in/lb torque.
Warning: Over tightening can break the studs from the base.
Figure 1-13. Tighten Up The Entire Assembly
Figure 1-14. 7/16” Socket and Torque Wrench Used to Tighten Assembly in Figure 1-13
Half clamp plate
Clamp plate - note
t h e s t e p f o r t h e
half plate