Rice Lake SURVIVOR SST3 Washdown Printer User Manual
Page 45
42
SST3 Installation Manual
15. Wrap a small hole grommet that is included with the printer around the cable with the small end of the
grommet pointing downwards. Orient the grommet split to a position that is 90 degrees to the split in the
split seal insert. (See Figure 5-36, left image) Press the grommet into the tapered hole in the split seal
insert. (See Figure 5-36, right image) At this time, position the cable as shown below. (See Figure 5-36,
bottom center image)
Figure 5-36. Insert Split Grommet Onto the Split Seal Plates
16. Place the half clamp plate onto the studs, then place the clamp plate onto the studs with the step facing
down and the half plate nesting in the step of the clamp plate.
Figure 5-37. Place Half Clamp Down on Assembly
Make certain slack is
present as shown in
p i c t u r e t o a l l o w
se aling of cable to
print case
Half clamp plate
Clamp plate - note
t h e s t e p f o r t h e
half plate