SINGER 18434 - Manual (Page 11)

11
CHANGING THE PRESSER FOOT
(B) (E) (J) (L)
Your machine comes with the General Purpose
Presser Foot already attached. You can easily change
to any one of the other presser feet which snap onto a
common shank by following the directions below.
• Raise needle to its highest position by turning hand
wheel toward you.
• Raise presser foot using presser foot lifter in back of
machine.
• Push toe of presser foot (1) up, until it snaps off the
shank (2).
• Take foot off machine.
• Place new foot under center of shank.
• Lower presser foot lifter, fitting shank over presser
foot pin (3).
• Don't turn screw. Instead, push presser foot screw (4)
down firmly until foot snaps into place.