Snow Joe iON18SB 40-Volt Cordless 18-Inch Single Stage Brushless Snow Blower w/ Rechargeable Ecosharp Lithium-Ion Battery - Manual (Page 7)

7
Discharge Chute Assembly
1. Lift the chute deflector until it locks securely into place on
the discharge chute.
2. Raise or lower the chute deflector to the desired height of
the snow stream.
3. Insert the gaskets into the middle of the chute connection
and tighten with the deflector knobs on each side
(Figs. 5 & 6).
NOTE: Do not overtighten the knobs.
Operation
NOTE: Before using this machine, make sure that the snow
blower’s roll shaft and rubber plates are firmly secured with
screws, and that the rubber plates are facing the correct
direction. Perform a test run to ensure that the rotor turns
freely.
Powering On and Off
1. Open the battery compartment cover and slide the battery
down to lock it into position (Fig. 7).
2. Insert the safety key into the slot and close the battery
compartment cover (Figs. 8 & 9).
Fig. 5
Gasket
Chute deflector
Fig. 6
Deflector knob
Screw
Fig. 7
Battery
Fig. 8
Safety key
Fig. 9
Safety key