Snow Joe TRJ601E-RM Trimmer Joe 4-Amp 12-Inch Electric Grass Trimmer/Edger - Manual (Page 7)

Winding the line
NOTE: A dual-line factory wound spool (Model TRJ601ERS)
is available for easy spool replacement on the TRJ601E
electric grass trimmer. Visit www.snowjoe.com to purchase.
Should you wish to wind the line yourself, the instructions are
provided below. Self-winding, however, is
NOT recommended
because if the line is not wound properly it can cause the
trimmer’s bump feed system to malfunction. For this reason,
users are strongly urged to purchase the pre-wound spool.
1. The spool can hold 20 ft (6 m) of line. Remove the white
cover. Holding the loose ends of the line together with
one hand, find the center of the line with the other hand
and hook this center loop into the groove on the spool as
shown in Fig. 10.
2. Wind the line following the directional arrows on the
spool housing and hook the two ends into the side
grooves (Fig. 11).
3. Firmly place the white cover on the spool and pull the
two ends approximately 3.5 inch (9 cm) out of the spool
(Fig. 12).
4. Along the groove, slide the line into the hole in the spool
cover (Fig. 13).
5. Prepare to assemble the spool into the trimmer.
Assembling the spool
NOTE: A dual-line factory wound spool (Model TRJ601ERS) is
available for easy spool replacement on the TRJ601E electric
grass trimmer. Visit www.snowjoe.com to purchase. When
using the factory wound spool, keep the protective white
cover encasing the line in place, then follow the directions
below to feed the line into the grass trimmer.
1. Insert the spring into the shroud and thread the line into
the hole as shown in Fig. 14.
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Spring
7