Symtech ATF 1 - Manual (Page 16)

15
Empty New Tank
The EMPTY NEW function is used to empty new transmission fluid contained in the NEW TANK into
an appropriate storage container. This allows the use of other types of transmission fluid in the unit
while minimizing cross contamination of fluid types. **See note on page 14
Connect any adapter to the intermediate adapter hose assembly. Connect the intermediate adapter hose
assembly to the RED new fluid line. Insert and secure the open adapter end into the storage container.
Depress the EMPTY NEW button on the control panel and the new fluid will begin to pump out of the
unit into storage container. The fluid will continue to flow until the level sensor in the NEW TANK
nears zero quarts in the tank. Also, depressing the STOP button on the control panel will stop this
procedure.
Upon completion of this process, disassemble the adapter and the intermediate hose assembly and
return them to their storage positions on the unit. Now add the desired new fluid type to the NEW
TANK via the fill cap located on the front panel of the unit. The unit is now ready to perform services
again.
NOTE: After filling system with new fluid type, empty approximately 1 quart of new fluid into
a receptacle to assure that all previous fluid type has been purged from system and
lines are now filled with new fluid type. Process below;
1.
Connect straight hose attachment to RED (New Fluid) hose and insert hose into receptacle.
2.
Press DIPSTICK button
3.
Press ADD FLUID button, and toggle the + button to show 1 quart.
4.
Press ADD FLUID button, 1 quart of fluid will be cycled through system into receptacle.
Empty Hose and Dipstick Wand Drippage
The NEW and USED coupler and the DIPSTICK extraction wand drippings are collected in a small
reservoir inside the unit. To periodically empty the waste fluid (check for high fluid level on dipstick
wand), connect black USED fluid hose to dipstick control valve. Connect dipstick wand to dipstick
control valve. Insert DIPSTICK extraction wand all the way into the rear storage hole, select
DIPSTICK mode, press REMOVE FLUID button and select 2.0 quarts. When all fluid has been
removed, press STOP button to reset unit.