Canon ImageCLASS MF4270 - Manual (Page 12)

10
Connect the Power Cord and Turn On the Machine
1
Connect the power cord into the rear socket on the back side of the machine and the wall outlet, and press
the [I] side of the main power switch (A) to ON.
2
The machine enters the standby mode.
1 0 0 % L T R
T E X T / P H O T O 1
Ex.
The LCD display turned off:
The machine may enter the sleep mode while you are setting up the machine. Press [Energy Saver] to turn the machine back on and
continue the setup.
<CLOSE COVER/TONER COVER> is displayed:
Make sure that the toner cover and scanning platform are closed properly. (See “Install Toner Cartridge,” on p. 5.)
<SET PAPER AGAIN/SET TONER AGAIN> is displayed:
Check the installation of the toner cartridge and the placement of the paper. (See “Install Toner Cartridge,” on p. 5 and “Set Up the
Paper Cassette and Load Paper,” on p. 8.)
Any data stored in the memory, including received fax documents, will be deleted if you turn off the main power switch of the machine.
●
●
●
Set Up the Machine