Universal Remote Control (URS) SR3 - Manual (Page 13)

3. Auto-Search Set-up
The Auto-Search Set-up scans through all of
the codes in the table to find the right code
for your component. Use this method for
components you cannot set up with either
the Quick Set-Up or 3-Digit Set-up. This
step is not difficult, but tests your patience,
as it takes about five minutes to work through
the entire table.
STEP 1: Turn on the component you want to
activate. (Other components can be on or
off, it doesn’t matter.)
STEP 2: On the URC-SR3, press the
Component button that you want to set up
and the SELECT [SEL] button at the same
time. Hold down both buttons for two
seconds until the Component button light
turns on. This signals that you are in set-up
mode and can release the buttons.
STEP 3: Point the remote control toward the
component and press the UP or the DOWN
arrow button on the nav igation pad. Each
time the UP or DOWN arrow button is
pressed, the code will count up (or down)
one code number and send a Power OFF
signal to the component.
Page | 12
COMPONENT
BUTTONS
SELECT
BUTTON
DOWN
6
ARROW
UP
5
ARROW