Universal Remote Control (URS) SR3 - Manual (Page 20)

Page | 19
What to know before you start:
• You can program up to 20 sequential
commands on a Macro button.
• You can program delays in between
commands by pressing the [PAUSE]
button on the transport control.
– Each press adds a one-half second
delay.
– If you add the delay time as the first
step of Macro commands, the remote
will not send the Macro unless the
button is held for two seconds.
• You can set up program macro commands
in layers by pressing the [STOP] button in
between commands. This will allow you
to rotate commands, and is typically used
to program channel lists. For example,
when working the “Favorites” buttons (A,
B, C or D), if you press [009], [STOP],
[035], [STOP], [365], [STOP] the remote
will send out 009 at the first press of the
selected Favorite button, and then send
out 035 at the second press, etc.
• You can set up the [CH
56
] or [PAUSE
;
]
buttons with macros.