Universal Remote Control (URS) RFS200 - Manual (Page 20)

37 38
ERASING COMMANDS
ERASING COMMANDS
Erasing Learned Buttons, Macros or Favorite Channels Erasing Commands - Overview
You can erase an individual button with a learned command, a macro or a favorite
channel. You can erase an ENTIRE Component’s learned command or macro buttons.
You can also erase ALL your learned commands on all Components or all your macros
or favorite channels everywhere.
If you really want a fresh start, it is possible to reset everything to the factory default
settings.
Erasing Learned Buttons, Macros or Favorite Channels
STEP 1:
Press and hold the MAIN and ENT (Enter)
buttons at the same time for approximately
3 seconds, until the word “SETUP” is
displayed at the top of the LCD screen. This
signals that you are now in setup mode.
STEP 2:
Press a PAGE button to display Page 2 of
Setup.
STEP 3:
Press the ERASE display button on the
LCD screen.
STEP 4:
Press either the LEARN, MACRO or FAV
button. The following screen appears:
ALL - Erases ALL of the specified
(Learned, Macro or FAV but-tons every-
where in the RF20)
DEVICE - Erases all learned or Macro
buttons in a single Component (NOTE:
This option is not available for FAVs.)
KEY - Erases one button only.
STEP 5:
If you press ALL, the RF20 displays a
“SURE?” button. After the SURE button is
pressed, all the buttons will be erased.
If you press DEVICE, a list of Components will
appear. Press the Component button that you
wish to erase. The bottom of the screen will
flash ERASE twice, then ERASED.
If you press KEY, you’ll have to navigate to
the Component and Page you want using the
MAIN, COMPONENT and PAGE buttons.
Press a button to erase it. The bottom of the
display will flash ERASE twice, then ERASED.
STEP6:
To return to normal operating mode,
press the MAIN button four times.
IMPORTANT:You now have 30 seconds to
perform the next step while you are in SETUP
mode. If you don’t press a button within 30
seconds, SETUP will disappear from the screen,
signaling that you have exited setup mode and
you will need to start over.
Erasing Learned Buttons, Macros or
Favorite Channels
SURE
BUTTON