Universal Remote Control (URS) RFS200 - Manual (Page 5)

7 8
Overview &
Pre-Programmed Code Method
Pre-Programmed Code Method
BASIC SETUP
BASIC SETUP
Basic Setup - Overview
There are two ways to program the RF20:
• The Pre-Programmed Code Method
• The Learning Method
The Pre-Programmed Code Method allows you to set up all the buttons at once, so
it’s the fastest and easiest of the two methods. The Learning Method allows you to
transfer functions from other remotes (old or new), one button at a time.
Pre-Programmed Code Method
STEP 1:
The pre-programmed 3-digit codes are
found in the back of this Manual on page
45. The codes are listed by Component
category (i.e., TV, VCR, DVD, etc.), then by
brand name. For instance, if you want to
locate a code for a Sony TV, first locate
the TV category, and then look for the
Sony brand.
Once you have located the 3-digit code (or
in some cases, several code numbers) for
the Component that you want to operate
with your RF20, write them ALL down on a
piece of note paper. It’s important that you
write down all the codes because
only one code is going to work for you.
STEP 2:
Now, turn on the Component you want to
program... let’s say your TV to start. Look
up your TV’s manufacturer setup code
from your reference list.
STEP 3:
Press and hold the MAIN and ENT (Enter) but-
tons at the same time for approximately 3 sec-
onds, until the word “SETUP” is displayed at the
top of the LCD screen. This signals that you are
now in setup mode.
IMPORTANT:
You now have 30 seconds to perform the next step
while you are in SETUP mode. If you don’t press a
button within 30 seconds, SETUP will disappear
from the screen, signaling that you have exited
setup mode and you will need to start over.
MAIN
BUTTON
ENTER
BUTTON