Universal Remote Control (URS) MX-650 - Manual (Page 19)

36 35
U n i v e r s a l R e m o t e C o n t r o l , I n c .
From the RF Settings Menu, select BLAST.
Decide whether you are changing the Blaster for all devices or just
one of the devices of the Omega.
Select ALL to change the blaster settings to
ALL devices in the Omega. Then, go to Step
4.
Select DEVIC to change the blaster settings to
just one of the devices in the Omega. Then,
go to Step 3.
The display changes to a list of the names of your devices. If you have
two pages of devices, pressing either of the page buttons will display
the other page. Select the device you would like to change IR/RF set-
tings, then go to Step 4.
Select the new setting by pressing the desired button, then press SAVE
to save your new setting and return to the RF settings menu.
T h e O m e g a
1
2
4
3
Select a device Page Button
displays the
other page
of devices.
Changes the cur-
rent front panel
BLASTER setting
Save the new setting
Exit this Menu with-
out changing the
EMITT settings
The display changes to a list of the names of your devices. If you have
two pages of devices, pressing either of the page buttons will display
the other page. Select the device you would like to change the
Emitter settings, then go to Step 4.
Select the new setting by pressing the desired button, then press
SAVE to save your new setting and return to the RF settings menu.
BLAST - Setting the Front Panel Blaster On or Off
The MRF-250 and MRF-300 Base Stations have a configurable
front panel high power IR LED or “blaster” for controlling compo-
nents in the same cabinet space without emitters attached to their
front panel. The front panel blaster can overpower or saturate the
sensors of some A/V components, so if intermittent operation
occurs, the blaster should be turned off.
The blaster is incompatible with a stack of identical components,
since all components will receive IR commands at once, no mat-
ter what device is selected. Turn off the front panel blaster by fol-
lowing the steps described on the next page:
3
4
Change the IR
line output
using UP and
DOWN buttons
Displays the
current IR line
output
Save the new setting
Exit this Menu with-
out changing the
EMITT settings
Select a device Page Button
displays the
other page
of devices.