Universal Remote Control (URS) MX-650 - Manual (Page 4)

6 5
U n i v e r s a l R e m o t e C o n t r o l , I n c .
Press the P-PRO button to select the Pre-Programmed Method.
The display changes so that you can select which Device button to
setup.
Press the device button you’d like to setup.
The bottom of the display will now flash “FROM TABLE”.
P-PRO
Button
T h e O m e g a
4
5
Press the
Page button
to display
the other ten
Device
names.
First ten
Device Names
Basic Setup
You can start setting up your Omega using either the Pre-Programmed
Method or the Learning Method. However, all the buttons of the Omega
are setup at once with the Pre-Programmed Method, so it is usually faster
than the one-button-at-a-time Learning Method.
Pre-Programmed Method
Power on the A/V component you wish to setup, so that you can test
codes by sending power off commands.
Refer to the pre-programmed code tables on pages 37 - 58 and
write down the code numbers listed for your A/V component. The
code numbers are listed by categories of devices, then by brand.
See page 37 for a category list. Code tables with model numbers
are available at www.universalremote.com in the MX-650 area.
Press and hold both the MAIN and ENT (Enter) buttons for approxi-
mately three seconds. The top of the display will show “SETUP”.
You are in SETUP mode now.
Note: You have 30 seconds to perform a step while you are in SETUP mode. If
you don’t press a button within that time, the Omega will time out and return to
normal operation.
MAIN
Button
ENT
Button
1
2
3