Universal Remote Control (URS) THZ-100 - Manual (Page 37)

Page 33
THZ-100 T
HERMOSTAT
Adjusting the LCD Time Out Time
The time out time for your thermostat LCD display is the time from the last
activity using the buttons to the time the LCD screen turns off.
If you desire to change the time out time of your thermostat LCD display
then use the arrow keys to move the highlight bar to LCD Timeout.
Press the key below the OK key label in the smart-key label at the bottom
right of the display to select this option. If you decide to cancel the operation
then press the key below the Cancel key label in the smart-key label at
the bottom left of the display.
After pressing OK, the screen updates to a screen that says LCD Screen
Timeout (Sec.)\ at the top of the screen and the current timeout time in
the center of the screen. Use the arrow keys to adjust the timeout time to
the value you desire. The value changes in 5 second increments and can
be set between 5 seconds and 120 seconds.
When you are satisfied with your timeout time selection then press the
key below the Set Time key label in the smart-key label at the bottom right
of the display to save your new value. If you decide to cancel the operation
then press the key below the Cancel key label in the smart-key label at
the bottom left of the display.
The third option at the bottom of the screen is Always On. If you select
the button below Always On, the thermostat returns to the main screen
and the LCD display remains on continuously.
If you enter the LCD Screen Timeout (Sec.) screen with always on previously
selected then the current timeout time display as three empty boxes in the
center of the screen and Always On is not be an option at the bottom of
the screen.