Vintage Cellars LECBILD1800 - Manual (Page 5)

B I L D W I N E C A B I N E T S
-5-
III. A S S E M B L Y I N S T R U C T I O N S
The following diagrams provide a step-by-step procedure to assemble the cooling unit.
When undertaking this process the following tips should be employed:
- A set of basic hand tools – flat and Philips screwdriver – will be helpful
- A second helper will be important when moving the panels, as they are quite heavy
- A large clean, padded area for laying out the pieces and raising assembled pieces
- Make sure the unit can be moved into its final location from the assembly area
- Ensure the doors seal well before moving on to next steps as this is a critical point
- The metal racks should not be forced into place as they will break – use a screwdriver
to open the brackets if the fit is too tight.