Vintage Cellars SENTRY III Plus - Manual

OWNER’S MANUAL
BREEZAIRE SENTRY III Plus Controller
This wine cooler controller is a specially designed state-of-the-art microprocessor
product which provides the user many flexible capabilities, plus a degree of built-
in safety features and “user friendliness” to provide a maximum of utility and
reliable operation for your wine storage benefit for years to come.
FEATURES OVERVIEW:
1. Adjustable storage temperature
2. Built-in compressor protection timing functions
3. Special alarm display features
4. Permanent retention of user adjustments during power outage
5. Independent selectable evaporator fan operation
6. Automatic Over-Heat protection
7. User-selectable operating and temperature display parameters
8. Automatic sensor error monitoring
9. Emergency manual operation
When the unit is first powered up, the display will momentarily show “
°
F” (or
“°C”), then the current wine storage temperature. If the temperature is above the
desired set-point, the unit will start cooling.
NOTE: During the initial power-up of the unit, you should leave the door to your
wine cellar or cabinet closed, in order to allow the unit to effectively cool the
storage space before storing your wines. If the initial temperature is above 70°F
and insufficient cooling is detected by the temperature sensor in the unit within
the first 30 minutes of operation, the unit will automatically shut off, and the
display will flash alternately “E1” and the temperature. You may re-start the
unit by (1) a manual RESET (see below), or (2) unplugging it for 10 minutes or
more.
A “call for cooling” will cause the right-hand decimal of the display to flash, then
will be on steady when the chiller actually runs. The chiller will run for a
minimum of 1 minute, for the compressor to stabilize.