Vintage Cellars Platinum Fully Ducted - Manual (Page 3)

Page 3
1. Install (8) 6-32 3/8” Phillips pan head screws in the locations below.
2. Connect the (2) keypad wires on the front wire terminal, black is positive red is negative. If display does not illuminate at initial
start up, revers the connection on the evaporator unit.
3. Install the side grill by aligning the (4) inside slotted holes with the (4) mounting screws and slide down.
4. Tighten the (2) bottom screws through the access holes followed by installing the (2) front screws.
5. Install the filter grille by aligning the (4) inside slotted holes with the (4) mounting screws and slide down.
6. Tighten the (2) bottom screws through the access holes.
Please refer to the Split System Owners Manual for remote keypad installation details.
1. Install (4) 6-32 3/8” Phillips pan head screws in the indicated locations.
2. Install the return air plenum by aligning the (4) outer holes and locking down, followed by tightening
the (4) Phillips screws.
3. Install the Supply Air Collar with (4) 6-32 3/8” Phillips pan head screws.
Please refer to the Split System Owners Manual for remote keypad and ducted installation details.
InstaLLIng tHe WaLL-MoUnt accessoRy kIt
InstaLLIng tHe DUcteD accessoRy kIt
1/16”
1/16”
note: The upper screws should be installed
with about 1/16” between the face and
screw head.
note: The upper screws should be installed
with about 1/16” between the face and
screw head.