Vinten Radamec Fusion Camera Control Unit (CCU) - Manual (Page 16)

5
Adding a new Channel
Fusion CCU models V4079-0001 (1 channel) and V4079-0003 (3 channel) can be upgraded at any time to
include additional channels. Each Fusion CCU can support up to five cameras.
1. Switch power off and remove power cable.
2. Disconnect all cables from the Fusion CCU rear panel.
3. Remove the Fusion CCU from the 19 inch rack.
4. With the Fusion CCU placed onto to a work bench or table, remove the four screws securing the lid. Lift
off the lid and place to one side.
5. Place the unit upside-down on a worksurface and remove the three screws securing the rear panel. Do
not disconnect any internal cabling to the channel connections (ETH and PORT).
6. Remove the blanking plate from the channel position. Remove the screws located on the outside of the
rear panel securing the blanking plate. Remove the blanking plate.
7. Plug in the new channel module. Carefully align the pins, ensuring that the pins do not bend or flex the
module PCB.
8. Fit the 9 way D connector to the back panel. Feed the D connector through the slot in the rear panel from
inside the Fusion CCU. Secure the connector into position using the screw jack, nut and washer.
9. Plug the cable connector into the 10 way header.
10. Ensure the gold shunt, located next to the 10 way header, is in position and secure.
11. Replace the rear panel and top cover.
12. Configure the IP address for the newly installed channel (module) following the process outlined in
Changing the Channel IP address
.
13. Install the Fusion CCU into the 19 inch rack and secure into position. Refit all cables and install the
cables for the new channel (module).
!
Warning!
Electrostatic Sensitive Devices
CAUTION! Support the rear panel. DO NOT allow the rear panel to fall away.