Vinten Radamec Fusion FH-100 - Manual (Page 24)

11
12. Enter the angle of travel (in degrees) either side of the zero datum position for both pan and tilt axes.
The positive direction of travel on the pan axis is in a clockwise direction when the Head is viewed from
above, and the positive direction of travel for the tilt axis is in a clockwise direction when viewed from the
left-hand side of the camera cradle as shown in Figure 8.
13. When done, click Apply and then OK to close the dialog box.
14. Click OK to close the Vinten Fusion Robot Control window (Figure 6).
15. Switch OFF the power to the Head.
16. Disconnect the lead from the USB port and reconnect the EPL cable.
17. Switch ON the power to the Head.
Figure 7 Set pan, tilt & height limits dialog box
(f) Pan maximum and minimum limits (g) Tilt maximum and minimum limits
Figure 8 Angles of travel on the pan and tilt axes
f g
Negative angle of
travel on the
tilt axis.
Positive angle of
travel on the tilt
axis.
Negative angle of
travel on the pan
axis.
Positive angle of
travel on the pan
axis.