Vinten Radamec Fusion FH-100 - Manual (Page 8)

v
Safety Guidelines
Please read this manual carefully before attempting to operate
the product. Retain this operators guide for future reference. This
manual should be read in conjunction with Operating Guides for
the Fusion Pedestal, Fusion Height Drive and the Vinten
Radamec Controller when accompanying the installation of the
Fusion FHR-120 Robotic Head.
Safety when working with the product
Take heed of warnings and instructions
You should read all of the safety instructions in this
Operators Guide before attempting to operate the
equipment. Adhere to all warnings in this guide and
on the equipment. Do not attempt to operate this
equipment if you do not understand how to operate
it.
Usage statement
This product is designed for use within television
studios to support and balance a camera together
with accessory equipment, allowing Operators to
remotely and manually control camera zoom and
focus, and movements about the pan and tilt axes.
The Fusion FH-100 Head can be operated in
robotic and manual modes. The total payload must
not be exceeded. The product is intended for use by
television camera operators, trained to use Vinten
Radamec robotic equipment. Do not use this
product for any other purpose other than that
specified in this usage statement.
Water, moisture and dust
Protect the product from water, moisture and dust.
The presence of electricity near water can be
dangerous. Do not use the product near water and
take care that liquids are not spilled onto the
equipment.
Operating environment
The product should not be used outside the
operating temperature limits. To prevent risk of
overheating, ventilate the product correctly. Refer to
the Technical Data section of this guide for the
operating limits for the product.
Power sources
Connect the product to a power supply of the type
and voltage rating described in the Technical Data
section of this Guide or as marked on the product.
For an emergency power-down, ensure all
personnel are aware of the location of the power
switch on the product and associated equipment
and power supplies.
IMPORTANT
!
Servicing
Do not attempt to service this product. Opening and
removing covers may expose you to dangerous
voltages or other hazards. Refer all servicing to
trained service personnel. Contact Camera
Dynamics Ltd or your local distributor to arrange
servicing of this product.
Connections
Turn OFF before connecting or disconnecting any
equipment or making any adjustments to the camera
or associated equipment.
Warning symbols in this operators guide
WARNING! Where there is a risk of personal injury
or injury to others, comments appear supported by
the warning triangle symbol. Where there is a risk of
damage to the product, associated equipment,
process or surroundings, comments appear
supported by the word ‘caution’.
ELECTRIC SHOCK Where there is a risk of electric
shock, comments appear supported by the
hazardous voltage warning triangle symbol.
FINGER TRAP Where there is a risk of trapping
fingers within parts of the product or other
equipment mounted to the product, comments
appear supported by the finger trap symbol.
Warning symbols on the product
On encountering the warning triangle and open
book symbols it is important that you read this
operators guide before using this product or
attempting any adjustment or repair.
Where there is a risk of electric shock, comments
appear supported by the hazardous voltage warning
triangle symbol.
OFF
!
CAUTION
finger trap
!