Vinten Radamec Fusion Virtual Reality box (FVR) - Manual (Page 4)

2
Safety & Warnings
Important information on the safe installation and operation of this
product. Read this information before operating the product. For
your personal safety, read these instructions. Do not operate the
product if you do not understand how to use it safely. Save these
instructions for future reference
Warning Symbols Used in these Instructions
Intended Use
The Vinten Radamec Fusion Virtual Reality (FVR) box is designed for
use with studio VR systems to interface with Vinten Radamec VR-
capable Fusion robotic pan and tilt heads and pedestals or height
drives.
The FVR box is intended to be used by television camera operators
within an indoor studio environment. Do not attempt to use this product
if you do not fully understand how to operate it.
Health & Safety
Safety when Working with Robotic Equipment
In normal operation remote-controlled equipment can move suddenly
and without warning. Since audible warnings are not suitable for use
within the studio environment, it is recommended that only trained
personnel be allowed to work in the active areas where remote-
controlled heads and pedestals are located. The safe operating zone is
a minimum of 1 m (3 ft). Do not operate robotic equipment if you cannot
see it.
Electrical Connection
Safety warnings and cautions are included in these
instructions. These safety instructions must be followed to
avoid possible personal injury and avoid possible damage to
the product.
WARNING!
Where there is a risk of personal injury or injury to others,
comments appear supported by the warning triangle symbol.
Where there is a risk of damage to the product, associated
equipment, process or surroundings, comments appear
supported by the word ‘Caution’.
ELECTRIC SHOCK
Where there is a risk of electric shock, comments appear
supported by the hazardous voltage warning triangle.
WARNING! Risk of personal injury or injury to others.
All personnel must be fully trained and adhere to correct
manual handling techniques and Healthy & Safety
regulations. It is the responsibility of the local organisation
to enforce safe working practices at all times.
WARNING! Risk of electric shock. Always disconnect and
isolate the product from the power supply before attempting
any servicing or removing the covers.
WARNING! Risk of electric shock. Always check cables
for signs of damage. Damaged cables can cause personal
injury and/or damage the equipment.
WARNING! The external DC PSU used must be approved
to IEC 60950-1, 2nd edition, and have a power output
limited to the requirements of the equipment.
CAUTION! This product must be connected to a power
supply of the same voltage (V) and current (A) as indicated
on the product. Refer to the Technical Specifications for the
product.