Vinten Radamec HS-102P Pan & Tilt Head - Manual (Page 18)

Operators guide
17
Installation
Mounting the head
The head can be mounted onto a tripod or pedestal, post, wall bracket or ceiling mount.
Attach the head to its mount using the six screws provided and tighten securely. To ensure a
secure mounting, the screws must protrude at least 5/16” (8mm) into the mounting plate [11] at
the base of the head. For upright mounts, use the bubble level on the top of the head to verify
that the head is mounted horizontally.
Vinten tripod mount
When mounting the head on to a standard Vinten tripod or pedestal, the Vinten 4 bolt adaptor
(AM-VMA-105) must be used.
1. Attach the Vinten adaptor [16] to the mounting plate [11] on the head using 6 screws
through the mounting holes and tighten securely.
2. Align the four bolts in the Vinten tripod or supplied with the pedestal with the threaded holes
in the adaptor plate [16] and tighten securely.
Wall bracket
1. Attach the wall bracket (AM-WBKT-102) to a solid structure using 4 suitable screws through
the 4 mounting holes [18].
2. Attach the head to the wall bracket using 6 screws through the mounting holes [17] and
tighten them securely.
CAUTION!
The installation of the head must be performed by competent and
trained personnel.
CAUTION!
For installations requiring overhead mounting, the head, camera and
accessories must be fitted with fall arresters that comply with all local
legislative requirements.
CAUTION!
The attachment of the wall bracket to a wall or other structure must be
capable of supporting the total weight of the head, camera and
accessories and must comply with all local legislative requirements.