Vinten Radamec HS-102P Pan & Tilt Head - Manual (Page 21)

HS-102P pan and tilt head
20
Electrical Connections
Power supply connection
The head is powered by either a rack mounted power supply (AM-PS27-5R) or a modular power
supply (AM-PS30-2). A combined power/data floor cable (AM-SP-CAB-XXX) connects between
the power supply and the Power/data connector on the head. The floor cable supplies the head
with power and data communications (to/from) the controller. Note that the environmental heads
(HS-102PE and HS-102-ITE) are supplied with an environmental floor cable (AM-HLE-CAB-
XXX) suitable for external installations.
1. Connect the appropriate floor cable from the HS-102P power supply to the head.
2. Connect AC power to the power supply.
Controller connection
The data connection between the controller and the head power supply is RS-422 data. The
VRC and LCS controller systems use data cable part number AM-LDD-CAB-XXX, and the
Multicontroller II system uses data cable part number AM-DD-CAB-XXX.
1. Connect the appropriate data cable from the controller to the HS-102P power supply.
Lens drive connection
The lens drive used with the head depends on the type of lens being used. The head can be
supplied with either the generic AutoCam servo lens drives (AM-SLD-102OE), the Vinten
Radamec native lens drives (AM-NLD-FED or AM-NLD-CED) or the video conference lens
interface (AM-VCL-IF).
Autocam servo lens drive
The servo lens drive can be mounted onto Fujinon or Canon lens. Connect the servo lens drive
cable to the lens connector on the head. If the lens drive requires adjustment, contact Vinten
Radamec for advise on setup and configuration.
Native lens drive
When using the head with the Vinten Radamec native lens drive, the floor cable is connected to
the NLD adaptor cable (V3990-5005) that provides connection between the head and the native
lens drive assembly (Fig. 9).