Vinten Radamec HS-102P Pan & Tilt Head - Manual (Page 25)

HS-102P pan and tilt head
24
Operation
The head has no external switches or controls. The head is operated remotely from the controller
using the joystick control panel or controller software. Always refer to the operating instructions
supplied with the controller for information on panning and tilting the head, and operating the
camera lens zoom and focus.
Joystick control
When the head is operated using the control joystick panel (Fig. 10):
Push the joystick left and right to pan the head. Depending on your preference, the
joystick sense can be configured so that pushing the joystick left causes the head to pan
to the left or to the right.
Push the joystick up and down to tilt the camera cradle on the head. Depending on your
preference, the joystick sense can be configured so that pushing the joystick up causes
the camera cradle to tilt up or tilt down.
Twist the joystick knob to zoom the lens in or out. Depending on your preference, the
sense of the zoom knob can be configured so that twisting clockwise causes the lens to
zoom in or zoom out.
Note that a separate Focus knob is provided on the control joystick panel to adjust the camera
lens focus.
Indicators
Two indicator LEDs are located on the connector plate of the HS-102P and HS-102P-IT. The
environmental versions HS-102PE and HS-102P-ITE do not have indicators. The power LED [7]
illuminates when DC power is supplied to the head from the power supply. The data LED [5]
illuminates when control data is supplied to the head from the controller.