Vinten Radamec Quattro SE HPM - Manual (Page 16)

14 Head Processing Module Operators Guide
Operation
Installing the HPM
The Vinten Radamec HPM seamlessly integrates with a Vector 950E or Vision 250E pan/tilt head
and Quattro-SE pedestal. Please refer to the relevant operators guides for detail on safely setting up
the pan/tilt head and pedestal.
Fitting to the head
The HPM is supplied with a mounting bracket (5) which attaches to fixing holes on the pan and tilt
head. If fitting the HPM to a Vector 950E head, position the head mounting bracket (5) as shown in
(Figure 2) and attach securely in place using the four fixing screws (8).
If fitting the HPM to a Vision 250E head (Figure 3), proceed as follows:
Remove the four fixing screws (8) in the corners of the pan encoder plate (20), leaving the two
central fixing screws (19) in place, retaining the pan encoder plate (20).
Leave the pan encoder plate (20) in place and position the head mounting bracket (5) on top as
shown in (Figure 3).
Attach the head mounting bracket (5) securely in place using the four fixing screws (8).
Figure 2 Fitting to a Vector 950E head
(8) (5) (4)
(14)