Vinten Radamec Quattro SE HPM - Manual (Page 17)

Publication Part No. V3851-4981 Issue 2 15
Power connections
Connect a standard IEC power cable to the HPM power supply unit’s input connector (4). The output
of the HPM power supply unit (13) is then fed through the cable clamp (14) and around the side of
the HPM, connecting to the power input socket (1).
CAUTION! When fitting a Vision 250E pan and tilt head/HPM configuration to a
Quattro-SE pedestal, ALWAYS fit the adapter ring kit (3354-900SP)
between the head and the pedestal weight tray—to avoid trapping
the ethernet, power and genlock cables.
Figure 3 Fitting to a Vision 250E head
WARNING!
Do NOT attempt to lift and carry the pan and tilt head via the HPM mounting
bracket (5).
NOTE: Also ensure that the (input) power lead (4) is secured by the cable
clamp (14) to prevent the HPM suddenly losing power if the cable
becomes snagged (Figure 2).
(5)
(19)
(20)
(8)