Welch Allyn AM282 Audiometer - User Manual - Manual (Page 9)

Directions for Use Introduction 5
Installation
1. Plug the power cord into the appropriate jack (R5) on the rear panel.
2. Plug the power cord from the Power Module into a line power (mains) outlet.
3. Plug the earphones into the earphone jacks on the rear panel. R3 is for the right and
R4 is for the left earphone/insert phone.
4. Turn the power switch to ON (R6).
Rear panel connectors
Symbols on the AM282 Audiometer
R1 Covered by a sticker and intended for service personnel only.
R2 Patient Hand Switch input jack (standard phone jack).
R3 Right ear phone output jacks (standard phone plug). Insert either the External Headset
or Internal Earphone jacks.
R4 Left earphone output jacks (standard phone jack). Insert either external headset or
Internal Earphone plugs.
R5 Power Input jack (2.1 mm pin).
R6 Power switch.
Symbol Description
Attention, consult accompanying documents.
Date of manufacture
CE Marked in accordance with the European Council Directive 93/42/EEC concerning
medical devices.
Special Recycling Required. Do not dispose in landfill.
Type B equipment.
Symbol for “CATALOG NUMBER.”