Welch Allyn Corival V2 - User Manual - Manual (Page 15)

Operator Manual Corival
15
B Programmable Control Unit Top 928810
B.1 Installing the Programmable Control Unit Top (option 928810)
When the option 928810 is ordered later on, it should replace the standard Control Unit.
Replacement should be carried out by service personnel only. For the description, we refer to
our user guide
supplied with this ergometer.
B.2 Control panel Corival with Programmable Control Unit (option 928810)
1. Display B (4x20 characters) directed to
operator
2. Infrared window (only active for option
928820)
3. One-step-back button
4. Down button
5. Up button
6. Confirmation button
B.3 Using the Programmable Control Unit
Check if the ergometer is properly installed.
In the display of the basic control panel the following appears for a few seconds:
Followed after a few seconds by:
At the same time the programmable control panel shows for a few seconds:
With an installed Bloodpressure Option it is followed for approximately 1 second by
(indicating correct operation of the BP device):
LODE ERGOMETER
TYPE
P= 0W 0 rpm
P-display
LODE
ver X.YZ