Welch Allyn TMX428CP Trackmaster Medical Treadmill - User Manual - Manual (Page 30)

Operating Instructions TRACKMASTER
6-2 TMX428 Owner’s Manual July 2014
Control Panel Display: The blue display screen in the center of the console provides information on
how to begin your workout and provides continuous user performance data throughout the workout
session. Additionally, it serves as a user interface allowing optional input of user information when a
new workout begins. The screen will prompt the user to input weight, age, and gender so that the
onboard computer can calculate a more accurate calorie burn and target heart rate. Heart rate
measurement is accessible through the use of the contact grips or by wearing a wireless pulse rate
watch or chest strap. The display screen allows the user to
simultaneously monitor; time, speed,
incline, distance traveled, pace, current heart rate, calories burned and METS.
The performance and feedback information provide on the blue display screen are defined as follows:
Time: The elapsed time of your workout session beginning with the initial movement of the belt and
ending when the stop buttons are pressed.
Speed: The speed at which the belt is moving. The belt starts at .1 M.P.H. and has a top speed of 15
M.P.H. Belt speed can be increased or decreased in .1 M.P.H. increments. This feature is capable of
displaying KPH.
Incline: The degree of incline of the walking surface. The starting incline is 0% and a maximum of
25%. The degree of incline can be increased or decreased in .5% increments.
Distance: The distance traveled in miles during the duration of the workout session beginning with
the initial movement of the belt and ending when the stop buttons are pressed. The distance is
measured in .1 of a mile. This feature is capable of displaying in Kilometers.
Heart Rate: The user’s current heart rate calculated in beats per minute when wearing a wireless
chest strap, wireless watch monitor, or by using the contact grips.
Calories: An approximate calculation of cumulative K-CAL expenditure for the exercise session
based on your body weight and the level of difficulty at which you are exercising.
Pace: Displays the number of minutes needed to run one mile or kilometer.
METS: Displays MET level
Control Panel Button Descriptions:
NOTE: You must attach the Stop Tether lanyard strap to your wrist before pressing any other
buttons on the TRACKMASTER
®
control. The lanyard will stop the moving running belt
should you fall.
Stop Tether: This switch is located on the console in the lower right hand portion, just right of
center. It is used in combination with a lanyard and wrist cuff which is to be worn by the user at all
times during the operation of the TRACKMASTER
®
. The opposite end of the lanyard has a plastic
“C” shaped piece that engages the Stop Tether which must be in place for the machine to run. Simply
insert the clip on the shaft directly behind the red cap on the switch. The TRACKMASTER
® is
designed to stop all functions upon activation of the Stop Tether. Operation cannot resume until “C”
shaped clip is returned to its operational position.