Welch Allyn Video Colposcope - User Manual - Manual (Page 17)

Directions for Use Components 15
Monitor
LINE A PARALLEL REMOTE RGB/COMPONENT
LINE B
~AC IN
IN
IN
IN
IN
IN
IN IN IN IN
OUT
OUT
OUT
OUT
OUT
OUT OUT OUT OUT
VIDEO
S-VIDEO G/Y
B/Pb
R/Pr
VIDEO
AUDIO AUDIO AUDIO
AC IN
socket
LINE A [S-Video composite
(BNC), (4 pin mini-DIN),
Audio (RCA pin)]
LINE B [composite
(BNC), Audio (RCA pin)]
PARALLEL REMOTE
(modular connector)
RGB/COMPONENT
(BNC), Aduio (RCA pin)
WARNING If peripheral devices (example: monitor, video printer, VCR ,other) do
not comply with IEC 60601-1-1, they must be kept out of the patient area (6 feet
minimum from patient).
WARNING All signal input and output (I/O) connectors are intended for
connection to only peripheral devices (example: monitor, video printer, VCR)
that are in compliance with IEC 60601-1 (General Requirements for Safety,
Medical Electrical Equipment) or other IEC standards (for example IEC 60950,
Information Technology Equipment – Safety) as appropriate to the nature of the
peripheral device. Connecting additional peripherals to the Video Colposcope
may increase the risk associated with chassis or patient leakage currents.
To maintain operator and patient safety, the User should consider the system
leakage current requirements of IEC 60601-1-1 (Medical Electrical Equipment,
Safety Requirements for Medical Electrical Systems). The user should measure
leakage currents accordingly to confirm that no electric shock hazard exists.
An isolation transformer that is in compliance with IEC 60601-1 used to power
the additional peripherals may be used to control the system leakage current
to comply with the requirements of IEC 60601-1-1.
Note Image is for reference only. Actual monitor may vary. Monitor shown is
SONY LMD-1410.
Use the video monitor provided by Welch Allyn or any video monitor that meets
the specifications listed on page 34.
For detailed instructions, please refer to the provided manufacturer’s operation
manual.