Using the command-line interface, Using the dell cmc, Figure 1-2 – Cisco 3130 User Manual
Page 19
1-9
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide
OL-13269-01
Chapter 1 Product Overview
Management Options
Figure 1-2
Device Manager Page
3.
Use the device manager to perform basic switch configuration and monitoring. Refer to the device
manager online help for more information.
4.
For more advanced configuration, download and run the Cisco Network Assistant, which is
described in the next section.
Using the Command-Line Interface
The switch command-line interface (CLI) is based on Cisco IOS software and enhanced to support
desktop-switching features. You can fully configure and monitor the switch from the CLI. You can
access the CLI either by connecting your management station directly to the switch console port or by
using Telnet from a remote management station. Refer to the switch command reference on Cisco.com
for more information.
Using the Dell CMC
See the Dell documentation for information about using the CMC.