Cisco 3130 - Manual (Page 14)

1-4
Cisco Catalyst Blade Switch 3130 for Dell and Cisco Catalyst Blade Switch 3032 for Dell Hardware Installation Guide
OL-13269-01
Chapter 1 Product Overview
Other Features
10-Gigabit Ethernet Module Slots
The switch 10-Gigabit Ethernet module slots are used for uplink connections to other switches and
routers. The module slots operate in full-duplex mode and use the Cisco TwinGig Converter Module.
The CBS 3130X-S uses the hot-swappable Cisco X2 transceiver modules and the Cisco TwinGig
Converter Module. The CBS 3130X-S supports these X2 transceiver modules:
• CX4
• LRM
• SR
For more information about the 10-Gigabit Ethernet module slots, see the “Installing Devices in the
10-Gigabit Ethernet Slots” section on page 2-21 . For cable specifications, see Appendix B, “Connector
and Cable Specifications.”
The Cisco Catalyst Blade Switch 3032G and 3130G support only the Cisco TwinGig Converter Modules,
not the X2 transceiver modules.
Cisco TwinGig Converter Module
The Cisco TwinGig Converter Module (model CVR-X2-SFP), also known as the converter module, has
two small form-factor pluggable (SFP) module slots that convert the 10-Gigabit slot into a dual
SFP module interface to establish Gigabit uplinks to network devices. The SFP modules have
LC connectors for fiber-optic connections or RJ-45 connectors for copper connections.
These are the supported Cisco SFP modules:
• 1000BASE-LX/LH SFP (GLC-LH-SM)
• 1000BASE-SX (GLC-SX-MM)
• 1000BASE-T SFP (GLC-T)
For more information about the Cisco TwinGig Converter Module, see the “Installing X2 Transceiver
Modules and Cisco Converter Modules” section on page 2-22 and the “Installing X2 Transceiver
Modules and Cisco Converter Modules” section on page 2-22 . For cable specifications, see Appendix B,
“Connector and Cable Specifications.”
LEDs
You can use the switch LEDs to monitor switch activity and performance. The System LEDs are
controlled by the Cisco IOS software. The System Status ID/LED is controlled by the Dell software. For
graphical representations of the LEDs described in this section, see the device manager GUI.
The LEDs are described in these sections:
• System LED, page 1-5
• Stack LED (Only the CBS3130G-S and CBS3130X-S Switches), page 1-5
• Stack Master LED (Only the CBS3130G-S and CBS3130X-S Switches), page 1-5
• Stack Member LED (Only the CBS3130G-S and CBS3130X-S Switches), page 1-6
• RJ-45 Uplink Port LEDs, page 1-6
• System Status/ID LED, page 1-6