Welch Allyn Health-o-Meter Professional Scales - User Manual - Manual (Page 10)

9
TROUBLESHOOTING (CONTINUED)
ERROR LIST
ERROR
NO.
DEFINITION CHECK/REPLACE
Err 1 Mathematical mistake; division by zero.
Cannot calculate calibration factor Will show when trying to calibrate with no
calibration weight
Err 2 Weight loaded too low. Cannot calibrate While in calibration procedure add more weight in
load mode
Err 3 Unstable weight. Cannot calibrate Check the load cells mechanical surroundings and
see nothing touches them and the cables are well
connected
Err 5 Calibration disabled Toggle the calibration switch to enable
Err 6 High saturation state (high A/D) The load cell is not connected correctly. Check
the connection, cables, and mechanical
connection. If the problem persists, replace the
set of load cells
Err 7 Low saturation state (low A/D) See Err 6
DETAILED VIEWS