Welch Allyn 1500 Patient Monitor Software version 1.4.X, - Quick Reference Guide - Manual (Page 2)

2
Connection and power up
The safety section in the directions for use must be read and understood before using the monitor.
1.
Connect the power cable to the input on the rear of the monitor (a).
2. Connect the potential equalization (ground) cable to the central
potential equalization lug (b).
3. Press the On/Off button (confirmed by a beep).
4. Confirm the New Patient dialogue by selecting Yes or No. The patient
data, patient mode, and other settings are selected and edited in
the Setup menu (see next page).
5. Check the settings.
a b
Parameter settings
1. Select the parameter by turning
the trim knob. A white box
appears around the selected
parameter.
2. Press the trim knob to display
the settings for the selected
parameter.
3. Select and confirm settings by
pressing the trim knob.
Trim knob
Temperature 1
CO
2
sampling
input (option)
CO
2
sampling
output (option)
ECG
NIBP
SpO
2
IBP1 to IBP4
(IBP3 and IBP4
options)
Cardiac output
and T2 (options)