Welch Allyn Holter Software PCH100 and PCH200 - Installation Guide - Manual (Page 18)

18
4. Activating the WA Holter Application License
You must activate your Holter software within 30 days, or the software will lock itself. The activation message displays each time you
launch the software until you activate. The best way to activate your software is through the Internet.
Note: Upgrading from version 1.0.0.2 may prompt the user to re-activate the software.
4.1 Activating through the Internet
4.1.1 Click on the Welch Allyn Holter System ICON located on the desktop.
4.1.2
The activation message displays.
4.1.3 Select Yes or No.
• If
you select No , a message displays reminding you that you must activate within 30 days. (Caution: after
30 days, the software will not launch.)
• If you select Yes , the system automatically activates itself and the activation screen will not display again.
This completes the activation requirement.
4.2 Activating Manually (No Internet Connection)
If the software cannot detect an Internet connection, you must activate the application manually.
4.2.1 Launch the Holter System software. The activation message displays.
4.2.2
Select Yes or No.
• If
you select No , a message displays reminding you that you must activate within 30 days. (Caution: after
30 days, the software will not launch.)
• If you select Yes , the Manual Activation dialog displays. Click the Print button. Contact Welch Allyn
Technical Support (see page ii). You will be asked to provide the information displayed on the printout:
9
Username
9 Password
9 PC Serial Number 1
9 PC Serial Number 2
4.2.3 Once you receive the Activation Code, type it into the Activation Code box and click Activate. The application
launches and the activation screen will not display again. This completes the activation requirement.
Proceed to section 5 to install SD card reader.
5. Install SD Card Reader
Overview:
The SD Card Reader allows the Welch Allyn Holter Software to Upload ECG Data from the Holter Recorder using the SD
Card.
Insert the USB cable with SD card reader attached into an available USB slot. The system should recognize the device and load the
appropriate drivers . Start the Welch Allyn Holter application. Go to the ‘Main Menu’. Double click which is located in the lower right
corner, and search for SD card reader. Select the appropriate drive and click ‘OK’.
Proceed to section 6 to USB Hibernation.