Welch Allyn Acuitylink Clinician Notifier, SW Install Instruction, Aculink Clin Not 1.4X - Installation Guide - Manual (Page 16)

12 Initialize the Clinician Notifier program on the mobile device Welch Allyn AcuityLink Clinician Notifier
To connect to the web service
1. In the Server IP Address page, tap Test.
The Connected to the Web Service popup window appears.
2. Tap .
3. Tap Save.
The Proceed Status page appears.
Note If a Notify Biomedical Engineering message appears, tap OK and Save, and
then consult with your facility’s IT department to ensure that the mobile
device association and connection settings are correct.
These settings are indicated in “Associate the mobile device with the
WLAN, and configure the device” on page 9.