Installing the cable-management arm, Installing the cable tray, Securing the cable-management arm – Dell PowerEdge 2600 User Manual
Page 21: Installing the cable-management arm -17, Installing the cable tray -17, Securing the cable-management arm -17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the Cable-Management Arm
This procedure is performed in two phases. First, install the cable tray into the back of the
system chassis. Next, install the cable-management arm on either side of the cable tray.
Installing the Cable Tray
Attach the cable tray to the system chassis using four 6-32 x 0.25-inch hex-head Phillips
screws (see Figure 1-14).
/j\ CAUTION: The cable tray cannot support the weight of the system. Do not grasp
the cable tray when lifting the system. Lift the system only by the chassis edges.
Securing the Cable-Management Arm
1
Facing the back of the rack cabinet, attach the right-angle bracket on the cable-
management arm to the cabinet’s back vertical rail and secure it with the captive
thumbscrews (see Figure 1-14). The bracket clamps into the square mounting holes
on the vertical rail.
Figure 1-14. Installing the Cable-Management Arm
R a c k I n s t a l l a t i o n G u i d e
|
1-17