Dell PowerVault 715N (Rackmount NAS Appliance) - Manual (Page 5)

Removing the Adapter Card
A
CAUTION: Before you perform this procedure, you must turn off the system and
disconnect it from its power source. For more information, see "Safety First—For
You and Your System" in "Troubleshooting Your System" in your Installation and
Troubleshooting Guide.
1 Turn off the system, ineluding any attaehed peripherals, and diseonneet the system
from the eleetrieal outlet.
2 Diseonneet any eables eonneeted to the eard.
3 Remove the eover (see "Removing and Replaeing the System Cover" in your
Installation and Troubleshooting Guide).
- Open the expansion-eard lateh.
5 Grasp the expansion eard and earefully pull it away from the riser-eard eonneetor (see
Figure 1-1).
6 If you are removing the eard permanently, install a metal filler braeket over the empty
eard-slot opening.
NOTICE: Install Ing a filler bracket over an empty expansion slot Is necessary to maintain
Federal Communications Commission (FCC) certification of the system. The brackets also keep
dust and dirt out of the system and aid in proper cooling and airflow inside the system.
7 Close the expansion-eard lateh.
8 Replaee the system eover, and then reeonneet the system and peripherals to a power
souree and turn on the system.
Updating Drivers
^ NOTE: When you install the Broadcom NetXtreme 10/100/1000 adapter card, your system
automatically Installs the device drivers. If you need to update your device drivers, perform the
steps in this section.
Beeause the system does not use a monitor, keyboard, or diskette drive, you must update its
deviee drivers from a Mierosoft® Windows® operating system-based elient system on the
network. To update the system’s drivers, you must first eopy the deviee drivers to the
network attaehed storage (NAS) system and then update them using Terminal Serviees.
^ NOTE: See the Dell | Support website at support.dell.com for the latest driver updates for your
card.
I n s t a l l i n g t h e A d a p t e r C a r d | 1 - 3