Set up the camera, A warning, Using a tripod – Canon Vb-C50fi User Manual

Page 30

Advertising
background image

2-4

1. Set Up the Camera

a WARNING:

Install the camera securely.

When installing the VB-C50Fi on the ceiling or a wall, contact your Canon dealer.
● When installing the VB-C50Fi on the ceiling or a wall, check that it is strong enough to

bear the weight of the VB-C50Fi including the mounting arm. Installation in a weak location
could result in the VB-C50Fi falling and causing serious injury.

● At least once a year, check for looseness in the camera installation mount. (If the optional

wide converter is used, check the converter mount also).

Note

The MAC address required when making network settings is shown on the rear of the

VB-C50Fi (

→ P.1-9). Please make a note of it before installing this unit (→ P.2-8).

Note

Do not overtighten the mounting screw.

If excessive force is used to tighten the mounting
screw, it may result in camera malfunction.

● Always use a tripod mounting screw that is less

than 6.0 mm (

1

/

4

in.) in length. The use of screws

6.0 mm (

1

/

4

in.) long or longer could damage the

camera. Also, the tripod seat used should be at
least 30 mm (1

3

/

16

in.) in diameter.

Firstly, set up the camera. Read the following carefully and make sure the camera is set up properly.

Using a Tripod

The screw for mounting a tripod is on the bottom of the VB-C50Fi.

Mounting
screw

Less than
6.0 mm
(

1

/

4

in.)

30 mm
(1

3

/

16

in.)

or wider

Installing the VB-C50Fi

Attach a mounting arm (not included) to the ceiling or a

wall and firmly attach the camera to the arm.

Advertising