Clarion RX755VD - Manual (Page 57)

English
Owner
’s
manual
VRX755VD
59
5.1 ch Surround Decoder Operations
Setting and storing P.EQ Properties
1. Press the [ADJ] button and touch the
[AUDIO] key.
2. Touch the [P.EQ] key to show the P.EQ
adjusting display.
3. Touch the key for the desirable type to select it.
The P.EQ adjustment contents are as
follows:
● SIGNAL
∗ The factory default setting is “P.NOISE”.
This function selects “P. NOISE” or “MUSIC”.
● SPEAKER SELECT
∗ The factory default setting is “FRONT”.
This function selects “FRONT”, “CENTER” or
“SURROUND”.
● BAND
∗ The factory default setting is “BAND1”.
Select the channel to be compensated
(“BAND1”, “BAND2”, “BAND3”).
● FREQUENCY
∗ The factory default setting is “1 kHz”.
Select the center frequency that you want to
compensate from the range of 18 Hz to 20
kHz. (1/3 octave step, 31 points)
● Q
∗ The factory default setting is “1”.
Set the sharpness of the Q-curve to one of
the parameters: 1, 3, 5, 7 and 20.
● GAIN
∗ The factory default setting is “0”.
Adjust the gain (output level) in the range of
–6 dB to +6 dB. (1 dB step, 13 points)
4. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
Selecting the Dolby PL II (Dolby Pro
Logic II ) type
∗ The factory default setting is “OFF”.
1. Press the [ADJ] button and touch the
[AUDIO] key.
Touch the [Dolby PL II ] key.
2. Touch the key for the desirable type to select
it.
3. When the setting is finished, touch the [ESC]
key or press the [ADJ] button to return to the
previous mode.
Output adjustment of subwoofer
volume, center volume and balance/
fader
1. Press the [ADJ] button and touch the
[AUDIO] key.
Touch the [DETAIL] key.
2. To make an adjustment on :
● Subwoofer volume adjustment
2-1. Touch the [SUBWOOFER VOL] key to
adjust to desirable level.
∗ The factory default setting is “0”. (Setting
range : –6 to 3)
● Center volume adjustment
2-1. Touch the [CENTER VOL] key to adjust to
desirable level.
∗ The factory default is “0”. (Setting range : –6
to 0)
● Balance/Fader adjustment
2-1. Touch the [BAL/FAD] key.
Touch the [ w ] or [ z ] key to adjust the
balance level.
[ w ] key : emphasized the sound from the
front speakers.
[ z ] key : emphasized the sound from the
rear speakers.
2-2. Touch the [ Å ] or [ Î ] key to adjust the
fader level.
[ Å ] key : emphasized the sound from the
left speakers.
[ Î ] key : emphasized the sound from the
right speakers.
3. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.