Casio PX720C - Manual (Page 30)

E-28
Assembling the Stand
To tighten the joint connector and screw
(1) Rotate the screw counterclockwise about three
turns to ensure that the screw is in the center of the
joint connector.
(2) Slowly rotate the screw clockwise and confirm that
it tightens without resistance. If you feel any
resistance, it means that the screw is not engaging
properly with the joint connector. Rotate the screw
counterclockwise again and try to get it to engage
properly.
(3) If you experience problems getting the screw to
engage properly, use a screwdriver to rotate the
joint connector 180 degrees. Next perform steps (1)
and (2) again to engage the screw from the screw
hole on the other side.
* Forcibly tightening a screw while it is not engaged
properly can strip the threads of the screw and joint
connector, making it impossible to tighten the screw.
• Perform steps 1 through 9 starting on page E-25.
10. Loosen the bracket screws at the bottom of
the stand’s side panels A and B to create a
gap between the side panels and corner
brackets as shown in the illustration.
11. As shown in the illustration, insert the pedal
unit brackets into to the gaps you created in
step 10.
12. Securely tighten the screws G that you
temporarily tightened in step 9.
• Cover the screw heads with the caps J.
Locating the Stand against a Wall
B A
Gap
G
J
B
PX720_03_e.fm 28 ページ ２００７年８月１０日 金曜日 午後２時２４分