Single display control, Note, Multiple displays control – Panasonic TYRM50VW User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Handling the remote control
•
Do not subject to strong shock.
•
Do not allow water or other liquid to splash the remote
control. If the remote control gets wet, wipe it dry
immediately.
•
Avoid exposure to heat and steam.
•
Other than to install the batteries, do not open the remote
control.
Single Display Control
To control one display, connect the “External IR Receiver^’ to
the [IR TRANSMITTER IN] port.
Point the top ofthe remote control toward the “External IR
Receiver” when pressing a button.
NOTE:
• The Display’s remote control sensor will stop working after
connected with the “External IR Receiver^’.
External
IR Receiver
Multiple Displays Control
To control a TV-wall set up by multiple displays, use the “External IR Receiver” and the “Connector cable of remote control”
found in the PD package.
External
IR Receiver
Display No.1
Display No.2
-(M li^
1. Connect the “External IR Receiver^’ to the [IR TRANSMITTER IN] port of Display #1.
2. Connect with the “Connector Cable” from the [IR TRANSMITTER OUT] port of Display #1 to the [IR TRANSMITTER IN] port
of Display #2.
3. Use the “Connector cable of remote control” to connect next display.
4. Point the top of the remote control toward the “External IR Receiver” when pressing a button.
NOTE:
• The remote control may not function properly if the “External IR Receiver^’ is under direct sunlight or strong illumination, or
when there is obstacle in the path ofsignal transmission.