Canon SCANFRONT 300P - Manual (Page 60)

5-8
Chapter 5 Operating Procedures
4.
Screen Displayed after Login
You can set the screen (Home screen or Job Button screen) that is displayed after a user logs in. (See p. 6-7 and p. 8-4.)
❏ Home Screen
a Select destination (E-mail, FTP, FAX, Shared
folder, USB memory, and Printer) buttons
These buttons open an address selection screen.
(See
“Scanning Procedures” on p. 5-13.)
Hint
• The USB memory button is enabled when USB memory is
inserted in a USB port.
• [Printer] is enabled when the ScanFront is connected to a
network environment that is running ScanFront Service.
b [User settings] button
Enables setting of the user password and fingerprint
registration (only with the ScanFront 300P).
(See “User
Settings Screen” on p. 5-9.)
c [Administrator setting] button
Opens the Administrator Settings screen. For details,
see “Configuring Administrator Settings” on p. 3-8 .
IMPORTANT
If a user whose use of the Home screen is restricted logs in, the
Home screen is not available. For details, contact the
administrator.
❏ Job Button Screen
This screen enables you to select a job button to scan using
the conditions registered to the job button, and then send
the image file.
(See “Scanning Procedures” on p. 5-13.)
IMPORTANT
• The document is scanned immediately after you press the job
button. Make sure to place your document before you press
the job button.
(See “Placing Documents” on p. 2-6.)
• Perform job button registration and editing via the Web menu.
• If you are unable to edit a job button, the editing of job buttons
has been restricted by the ScanFront administrator. For
details, contact the administrator.
a
c b